RABH filter bag Features

1000m2 bag arrangement number is the number of rows in the arrangement 2W2; 3000-9000m2 are arranged in rows in 2W4W2 under; 1800m2 is the number of rows in the arrangement under 3W3 about; 10.000m2 is to pass around the pipe arranged in rows under. (W on behalf of the Access) 729 and 734 into the […]

RABH filter bag

Cleaning bag filter bag filter cleaning it is widely used in steel mills, smelters, cement, carbon black plants, power plants and other enterprises smelting, crushing, screening and soot produced by combustion purification and recycling. Blowback bag filter points positive pressure (also known as push-in) and negative pressure (also known as inhaled), described in this specification […]

What’s the properties of geotextile?

Q: What’s the properties of geotextile? A: 1. Make use of geotextile’s good air permeability and water permeability, water flows through, it will effectively retain sand loss. 2. Make use of good water conductivity properties, which can be formed inside the soil drainage channels. 3. Make use of geotextile tensile strength and resistance to deformation of soil, enhance the stability […]

Posted in FAQ

Can PTFE can be insulation ?

Q:Can PTFE can be  insulation ? A:PTFE has insulating properties , articles made , such as rods, tubes , films, shaped pieces and so has insulating properties , but note that , since the material recovered contains impurities , it is not necessarily insulated ! cheap nfl jerseys Participating after work is difficult for many […]

Posted in FAQ

Baghouse works principle

Bag filter is the most widely used air pollution prevention and control dust, but also the most efficient dust precipitator. Process bag filter dust: dusty gas from the inlet port into the middle of the box into the bag from the outer and inner bags, dust blocked in the outer surface of the bag, clean […]

Can the PTFE be used in the food industry?

Q:Can the PTFE be used in the food industry? A:First investigate the country , some countries do not allow food and drug law is not that way . In general , PTFE is used in the production and consumption throughout the manufacturing process are without heating or heating temperature is below 120 degrees of food […]

Posted in FAQ

Baghouse design elements(4)

Inlet dust concentration Inlet dust concentration often dusty quality standard state volume, said on the inlet dust concentration, baghouse design should make the following considerations (1) Equipment resistance and cleaning cycle. Inlet dust concentration increases, the same filter area, the device also increases the resistance in order to maintain a certain degree of resistance of […]

Baghouse design elements(3)

Gas components Except in special circumstances, the gas bag filter being handled, mostly ambient air or furnace flue gas, normally baghouse design by process air is calculated only in density, viscosity, heat capacity and other parameters related to the design of wind turbine power performance and pipe resistance computing and cooling apparatus, before considering the […]