Author Archives: shengjie

1, a filter can only be marked above the nameplate rated voltage / frequency of use. 2, from time to time to deal with maintenance filter. Before cleaning and maintenance, be sure to disconnect the power supply filter. 3. Make sure that the electrical plug is not wet cleaning otherwise before re-power plug must be […]

Gas Filter Design features? 1, the filter device uses patented internal mechanical structure, to achieve a true sense of the high-pressure backwash function, it can easily and thoroughly clean the filter retention of impurities, cleaning no dead ends, the flux without attenuation to protect the filtration efficiency and long-term life. 2, filtration equipment used 304,316L […]

Unscrew the discharge valve inside the air filter; Unscrew pressure plate, open the top cover; Unscrew and remove the five gland, and then remove the filter from the filter; Clean the filter surface and corrugated section; The loaded cleaned or new filter in the filter, ensure proper installation and sealing; Close the top cover, tighten […]

Before running the filter make sure that all the valves are installed; Ensure the filter is placed vertically, the pump outlet and the filter inlet connection; Unscrew the drain valve on the filter cover; Pump power supply is turned on to let the pump run until the filter all the air is discharged, the water […]

Unscrew the screw platen, open the top cover. Installation 5 in the filter cartridge correctly, with five of the gland pressed and fixed; The pressure gauge and vent valve mounting screw hole on the filter cover the reserved (gauge customer); Cover cap, tighten the gland plate without excessive force; Ensure that the filter is placed […]

Factors causing excessive bag filter dust emissions : 1, The initial layer of the surface of the bag filter bag is not enough During the dust collector working, if the operating pressure excessive emissions and dust than low design is likely to be less than the initial surface layer of the powder bag, the reason is […]

1 bag clogging. When the bag clogging, so that the resistance increased by increasing the differential pressure gauge readings show. Bag bag blockage is the main cause of wear, perforations, loss and other phenomena. Blockage caused bag (1) temporarily strengthen cleaning to eliminate clogging of the filter bag; (2) partial or total replacement of the […]

1. Air filter Contaminated air is clean to the state the production and living needs, that is, the air reaches a certain cleanliness. 2. Liquid Filter Contaminated liquid is clean to the state the production and living needs, that is, the liquid reaches a certain cleanliness. 3. Network filters By setting to block spam, resorted […]

1, A fluorine Mae dust bag filter speeds up to 1.0m / min or more, and low running resistance, abrasion resistance and fracture resistance and peel strength has increased significantly, the use of temperature up to 260 degrees, the use of Teflon treatment, extensive used in steel, non-ferrous metallurgy, chemical industry, carbon black, building materials, electricity […]