How do we make a daily maintenance of the dust collector filter bags ?

Q:How do we make a daily maintenance of the dust collector filter bags ?

A: Filter bags as the heart of Baghouse dust collector, its routine maintenance and repair to extend the baghouse life is very important. Since the initial layer of dust filter bags, because the assembly is not in place of, or damage will result in dust emissions exceeded. 1, If the dust collector filter cut emissions exceeding the operating pressure is much lower than designed, it is likely that the initial layer of the bag shortage may be due to the filter bag when the speed is too high, blowing compressed air pressure too high, or too short cleaning cycle of bag and other causes. In this case ,it should set bag cleaning cycle to the maximum time, improve precipitator outlet pressure constant social stability. But if excessive emissions Integrator is in the bag after cleaning, you should check whether it is under the pressure of compressed air caused by too much. 2, Dust collector filter bag breakage, wear, etc. In the baghouse maintenance, bag maintenance costs always occupy the largest proportion. So usually it should be noted that the adjustment of the exhaust gas flow precipitator, when the larger flow, it should increase the flow of automatic control system to ensure dust can work in a stable gas. And uneven intake air bag is easy to make some part of a blow causing perforation bag breakage. This time should be installed at the air inlet duct intake distribution guides or replace more wear-resistant bag. Particular attention is the distance between the keel and the bag should pay attention. Keel welding burrs when there is often likely to cause breakage of the bag. Another is that, due to the long period of high temperature exhaust gas bag, easily melting temperature of the exhaust gas generated holes. This time to the timely replacement of the bag. 3, The bag is also easy to clogging. Among the most frequently clogging is water. Therefore, usually to avoid undue power, be careful not to large dust resistance when the boot, the boot below the dew point in time, when there is air infiltration due to dust and then when the temperature in the first low temperature, moisture can also easily problems.